The best way to figure out what's going on with your Pulse is by pressing the reset / setup button. It's located next to the power plug and you need a paperclip or pen to poke it. After pressing the button, the light on the front of the Pulse will blink for about one minute (don't worry, this light turns off, and only turns back on if the Pulse loses power, and in no other circumstance).
For troubleshooting, only the sequence that happens soon after releasing the reset button matters. If it starts blinking red, but then goes to green/yellow after 30 seconds - it is the red sequence that is important for troubleshooting.
1. One long red, two short red:
This sequence means that the Pulse is looking for the wifi network, and cannot find it. Typically that is because the network name that the Pulse is looking for is incorrect, or is a 5GHz network. If you have trouble, contact support - email@example.com or 1‑888‑53‑PULSE (888-537-8573)
Clear the configuration, correct the network name, and do blinkup again.
2. One long red, three short red
This sequence means that the Pulse has the wrong password saved to it - try confirming the password and trying again. If you continue getting the error, it could be an issue with your router. Try restarting your internet router (unplugging, waiting for 30 seconds, and plugging it back in) and then trying again.
Clear the configuration, correct the password, and do blinkup again. If you have trouble, contact support - firstname.lastname@example.org or 1‑888‑53‑PULSE (888-537-8573)
3. Random red sequence when on battery power
This may mean that the batteries are too low. Switch to AC power, or replace the batteries.
1. Blinking yellow
This sequence means that the Pulse does not have any wifi information on it yet. Try doing blinkup again, make sure to read the tips in the "Before you begin" section here. If you have trouble, contact support - email@example.com or 1‑888‑53‑PULSE (888-537-8573)
1. Solid green
This sequence means that the Pulse just performed a successful blinkup, and the wifi information on the device has been updated.
2. Faint, intermittent green blinking
This indicates some sort of power issues.
- If both plugged in and on battery, try taking out the batteries or unplugging it.
- If just plugged in, try a different power cord and power adapter.
- If just on batteries (unlikely), try switching the batteries out or plugging it in.
- If none of that works, contact support - firstname.lastname@example.org or 1‑888‑53‑PULSE (888-537-8573)
3. Blinking green
This sequence means that the Pulse is connected and working fine.
Green and Yellow Lights
1. Alternating blinking green and yellow
This sequence means that the Pulse is intentionally disconnected. Restart the Pulse and check the light code it settles into. If it goes through a few sequences but reaches this light sequence in 5-10 seconds, everything is likely working fine.
Red and Yellow Lights
All of these sequences should be short lived, and mean that the Pulse is going through the connection process. If they last for a while, you're likely having connection issues. Try resetting your router, waiting a minute, and then pressing the reset button on the Pulse. If you have trouble, contact support - email@example.com or 1‑888‑53‑PULSE (888-537-8573)
1. Red, yellow, off, repeat
2. Yellow, red, off, repeat
3. Yellow, off, short red, off, repeat